MIDI JackPlate: VANCE JPL4000 5” (6”with angle)

VANCE JPL4000 5/6″ MIDI manual Jackplate:

• Two-piece, lightweight, but strong and cost-effective design, with adjustable stainless steel screws on both sides
• Popular, entry level product for smaller bolted motors on BIA standard hole pattern, even interchangeably regardless of any engine brand, recommended til 100Horse Power!
• Factory pre-drilled standard BIA hole pattern (327mm on the top, 237mm on the bottom, 203mm vertical spacing)
• Optional 2.54cm (+10mm profile thicknes) thick StarBoard Clamper plate surface for mounting smaller motors with clampered hanging (for Power Trim or gas spring motors but clampered engines)
• MADE IN USA: Made of high strength polished 10mm thick Aircraft Quality Aluminium Alloy
• Basic 5 inch setback, meaning 12,70cm transom-engine ofset, longitudal JackPlate size
• Adjustable transom angle, 6inch (15,24cm) setback on the top of the jackplate, 5inch (12,70cm) on the bottom, so can modify the basic transom angle with this possibility
  (The only jackplate which is not paraller on both side with this adjustment!)
• 1,5 inch, meaning 3,81cm basic vertical lift, basic height difference between transom, and engine side, but holes avaiable on the engine side on the same height level
• Possibility to raise the height 4 inches, 10.16 cm in parallel, through the screws on both sides of the structure for lifting the outboard engine
• Alltogether 5,50inch, so 13,97cm possible outboard engine height lifting
• Basic RAW aluminium surface, but optionally hard black, or clear anodizing surface for saltwater or brack water usage protecting the hardware against natural corrosion
• Lightweight, but strong construction with a total weight of 9.07 kg, ideal for cost-effective mounting of small and middle ranged outboard engines
• The JPL4000 5 ”is also suitable for correcting the verticality of beveled motors, or modifying transom angle

Brochure

Optional possibilities:

The basic VANCE JPL4000 MIDI JackPlate ready to use, immediatelly capable to use product, but could be upgraded with the following optional elements:

Colour and surface: Basic RAW surface on the basic product!

• Hard Black anodizing for the premium look, or corrosion resistance for saltwater usage individually ordered (CODE: HBA)
• Clear Water anodizing surface for corrosion resistance for saltwater usage individually ordered (Code: CA)

Transom strengtening solution for inside the boat:

• Transom Plate upper, Optional, always on warehouse (CODE: TP210)
• Transom Plate lower, Optional, always on warehouse (CODE: TP211)

Upper Transom plate recommended from 100HP, and both above 150HP

JackPlate Clamper Plate, for smaller clampered, hanging engines:     

2,54cm thick, white StarBoard with B.I.A hole pattern Optionally ordered (CODE: SB701W)

Bolt kit: Screws, washers and nuts for installation: (Complete package):

• Transom side 4 pieces (d12mm,100mm, A2 Grade)
• Engine side 4 pieces (d12mm, 50mm A2 Grade)

Optional, allways on stock! (CODE BKBIA)

Silicon: For insulation, waterproof installation of the jackplate

• SIKAFLEX white Optional, allways on stock! (CODE: SKFLX)