VANCE SALT WATER JackPlate: VANCE JPL7500SS 6” for Offshore Usage

VANCE JPL7500SS 6″ stainless steel manual jackplate:

• Medium sized, robust, premium quality STAINLESS STEEL manual JackPlate for up to 225Hp, maximum 300kg outboard engines
• Powerful and strong, original one-piece JackPlate, with 3-3 secure bolts on both sides, and centralized lifting screw for the engine height, and for the biggest performance
• Recommended product for engines with hydraulic steering solution!
• Typical product for mounting bolted motors on BIA standard hole pattern, even interchangeably regardless of any engine brand til (175HP*)
• Factory pre-drilled standard BIA hole pattern (327mm on the top, 237mm on the bottom, 203mm vertical spacing)
• MADE IN USA: Made of high strength stainless steel 304L for prolonged salt water use or brackish water, so offshore usage with longlife corrosion resistance
• COMMON size JackPlate: 6 inch setback, meaning 15,24cm transom-engine ofset, wide spread longitudinal JackPlate size
  Salt Water Jackplate is only avaiable with 6inch, so 15,24cm setback
• 1,5 inch, meaning 3,81cm basic height difference between transom, and engine side, but holes avaiable on the engine side on the same height level
• Possibility to raise the engine height for 4 inches, 10.16 cm in parallel, through the centralized lifting screw
• Alltogether 5,50inch, 13,97cm possible outboard engine height lifting
• Powerful, sturdy corrosion resistant manual Jackplate with 20,241Kg overall weight, ideal for secure mounting of the upper-mid ranged outboard engines for offshore usage

Brochure

Optional possibilities:

The VANCE JPL7500SS 6” SALT WATER JACKPLATE is ready to use, immediatelly capable to use product, but could be upgraded with the following optional elements:

Colour and surface: This is a stainless steel jackplate, no coating options aviable!

Transom strengtening solution for inside the boat:

• Transom Plate upper, Optional, always on warehouse (CODE: TP210)
• Transom Plate lower, Optional, always on warehouse (CODE: TP211)
  Upper Transom plate recommended til 100HP, and both above 150HP

JackPlate Clamper Plate, for smaller clampered, hanging engines:     

2,54cm thick, white StarBoard with B.I.A hole pattern, Optionally ordered (CODE: SB701W)

Bolt kit: Screws, washers and nuts for installation: (Complete package)

• Transom side 4 pieces (d12mm,100mm, A2 Grade)
• Engine side 4 pieces (d12mm, 50mm A2 Grade)

Optional, allways on stock! (CODE BKBIA)

Silicon: For insulation, waterproof installation of the jackplate

SIKAFLEX white, Optional, allways on stock! (CODE: SKFLX)